Mini Porch

My porch floor is finished! It’s so pretty and new that I don’t want to step on it with my dirty work boots!

It’s taken a lot of little steps to get the porch done. I covered most of the work in my last post, but I still spent six hours today working on it, as well as several hours throughout the week. I did a third coat of paint on the post. I primed and spray painted the porch and the back of the trailer (after sanding away a few spots of rust).

The porch has so many weird little corners that I needed to figure out. First off, the side wall sheathing was installed while the plywood porch was in place, so when I took the plywood out, I had a 5/8″ gap to deal with. I was planning on notching the porch boards to fit, but then I realized gluing in a strip of plywood would be way easier. I decided to paint it purple, so in the gaps between the porch boards, you would see a little colour.

I glued in the piece, then I thought I should caulk it as well, so no water can get stuck behind the piece.

20170507_153545

No more purple, oh well.

I spent a while fiddling with the boards to get them just right.

20170507_141456

Test fit!

I marked them, then predrilled, countersank, and set the screws partway in.

The edge of metal on the right side of the porch was simply not wide enough to accommodate the thick screws for drilling into the trailer, so I used some heavy duty adhesive. The first piece is almost completely underneath the threshold of the door, so that piece doesn’t have any screws in it:

20170507_165417

First piece down!

I didn’t want to put any screws into the flange (the 3 1/2″ on the left) where they’d be exposed, and besides, the wiring for the trailer lights runs underneath there. So that’s why there are no screws on the left.

After that I glued down the next five pieces and clamped them. Then I used the impact driver and burned through some screws and an hour or two. Drilling into metal is not fun! But it’s done! Oh and one screw unfortunately lined up exactly with some c-channel underneath, so it couldn’t tighten up and had to be glued in.

I shimmed the threshold because it was just a little higher than the decking:

20170507_190209

Then some caulking and it was finished!

20170507_202622

πŸ™‚

The boards are spanning three feet and bowed a little when you stepped on them, so the green screws in the center are for some support pieces underneath. My sis helped me with those. πŸ™‚

My porch floor is done, so now I can get the trim up around the door and on those corners, and get the siding going!

20170507_204410

I’ll get some less fuzzy pictures soon. πŸ˜›

20170507_204450

P.S. I bought a third caulking gun, and it works amazingly. It is fifty times easier to use than the others I’ve used. I caulked around the octagon before I bought the new gun, and I was switching back and forth between two half-broken ones. With the new one, it took less than 20 minutes to caulk and tool one window, when before it was taking over an hour! I easily finished the last two windows, as well as around the wheel wells. πŸ™‚

20170505_141159

$5, $10.50, & $13.50, respectively.

The porch ceiling will be the last exterior piece to go up. Trim and siding first!

It’s been a great week. I’ve been picking away at little to-do’s like priming and painting the plywood edges to protect them. I put together my porch! I’ve been researching HRVs and HVACs, as well as fans and vent hoods. I also did some 3D modeling of my future furniture, and it’s looking good!

It was pouring rain last night, so I went out and laid in my loft for a while, smiling in my little house that I built, listening to the rain, protected. I need to do something about the rain loudly hitting the wheel wells though…

And today was T-shirt weather! I had the windows in the tiny house open. πŸ™‚ Cheers to warm weather!

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

Quotes

"It takes as much energy to wish as it does to plan." - Eleanor Roosevelt

"It is not because things are difficult that we do not dare. It is because we do not dare that they are difficult." - Seneca

"Have nothing in your house that you do not know to be useful or believe to be beautiful." - William Morris
%d bloggers like this: